Telit Wireless Solutions LE910C series - Page 777

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 777 of 1904 2022-03-04
Not Subject to NDA
Value:
0÷max
:
use test command to know the values
range
<peak>
integer
0
peak throughput class
Value:
0÷max
:
use test command to know the values
range
<mean>
integer
0
mean throughput class
Value:
0÷max
:
use test command to know the values
range
If a value is omitted for a particular class then this class, is not checked
AT+CGQREQ=<cid> is a special set command syntax that delates the
PDP context identified by <cid> index.
AT+CGQREQ?
Read command returns the current settings for each defined context in the
format:
+CGQREQ:<cid>,<precedence>,<delay>,<reliability>,<peak>,<mean>[<CR><LF>
+CGQREQ:<cid>,<precedence>,<delay>,<reliability>,<peak>,<mean>[...]]
If no PDP context has been defined, it has no effect and OK result code
is returned.