Telit Wireless Solutions LE910C series - Page 785

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 785 of 1904 2022-03-04
Not Subject to NDA
for IPv4:
"a1.a2.a3.a4.m1.m2.m3.m4"
for IPv6:
"a1.a2.a3.a4.a5.a6.a7.a8.a9.a10.a11.a12.a13.a14.a15.a16.
m1.m2.m3.m4.m5.m6.m7.m8.m9.m10.m11.m12. m13.m14.m15.m16"
When +CGPIAF is supported, its settings can influence the format of this
parameter returned with the execute form of +CGCONTRDP.
The dynamic part of the PDP context will only exist if established by the
network. The test command returns a list of <cid>s associated with active
contexts.
If the MT has dual stack capabilities, two lines of information are returned
per <cid>. First one line with the IPv4 parameters followed by one line with
the IPv6 parameters.
AT+CGCONTRDP=?
Return the list of <cid>s associated with active contexts.