Telit Wireless Solutions LE910C series - Page 835

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 835 of 1904 2022-03-04
Not Subject to NDA
PDP contexts associated to one PDP address. At an attempt to delete a TFT, which
would violate this rule, an ERROR or +CME ERROR response is returned. Extended
error responses are enabled by the +CMEE command.
Possible Response(s):
OK
ERROR
Parameters:
Name
Typ
e
Def
aul
t
Description
<cid>
int
ege
r
-
a numeric parameter which specifies a particular PDP
context definition (see the +CGDCONT and +CGDSCONT
commands). The following parameters are defined in
3GPP TS 23.060 [47]:
<packet
filter
identifier
>
int
ege
r
-
The value range is from 1 to 16.
<evaluati
on
preceden
ce index>
int
ege
r
-
The value range is from 0 to 255.
<source
address
and
subnet
mask>
stri
ng
-
The string is given as dot-separated numeric (0-255)
parameters on the form:
"a1.a2.a3.a4.m1.m2.m3.m4" for IPv4 or
"a1.a2.a3.a4.a5.a6.a7.a8.a9.a10.a11.a12.a13.a14.a15.a16.
m1.m2.m3.m4.m5.m6.m7.m8.m9.m10.m11.m12.m13.
m14.m15.m16", for IPv6.