Telit Wireless Solutions LE910C series - Page 934

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 934 of 1904 2022-03-04
Not Subject to NDA
<cmdType>=20 (SEND DTMF)
<cmdType>=32 (PLAY TONE)
<cmdType>=64 (OPEN CHANNEL)
<cmdType>=65 (CLOSE CHANNEL)
<cmdType>=66 (RECEIVE DATA)
<cmdType>=67 (SEND DATA)
the URC has the following extended format:
#STN: <cmdType>[,<alphaIdentifier>]
If <cmdType>=19 (SEND SHORT MESSAGE) fails, the #STN: 119 URC is sent to
the module.
<mode>=2, and <cmdType>=33 (DISPLAY TEXT), the URC is sent if allowed by
SIM/USIM, the extended format is:
#STN: 33[,<cmdDetails>[,<alphaIdentifier>]]
If bit 7 of <cmdDetails>=1, the response with the #STSR command is required.
<mode>=2, and <cmdType>=34 (GET INKEY), the URC has the following
extended format:
#STN: 34,<cmdDetails>,<text>
<mode>=2, and <cmdType>=35 (GET INPUT), the URC has the following
extended format:
#STN: 35,<cmdDetails>,<text>,<responseMin>,<responseMax>[,<defaultText>]
<mode>=2, and <cmdType>=36 (SELECT ITEM), the URC has the following
extended format:
the first line of output is:
#STN: 36,<cmdDetails>,<numOfItem>[,<titleText>]<CR><LF>