Telit Wireless Solutions LE910C series - Page 938

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 938 of 1904 2022-03-04
Not Subject to NDA
In SAT/USAT applications an SMS message is usually sent to the network
provider containing service requests, e.g. to send the latest news. The
provider returns a message with the requested information. Before
activating SAT/USAT, it is recommended to set the SMS text mode with the
AT+CMGF=1 command and enable URC for incoming SMS messages with
+CNMI command.
AT#STIA=?
Test command returns the range of available values for the parameters <mode>
and <timeout>.