Telit Wireless Solutions LE910C series - Page 1233

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1233 of 1904 2022-03-04
Not Subject to NDA
if <srMode> = 1 (Data amount):
SRING: <connId>,<recData>
if <srMode> = 2 (Data view):
SRING: <connId>,<recData>,<data>
if <srMode> = 3 (Data view with UDP datagram information):
SRING: <sourceIP>,<sourcePort>,<connId>,<recData>,<dataLeft>,<data>
Name
Type
Default
Description
<recData>
integer
-
amount of data received on the socket
connection number <connId>
<data>
mixed
-
data received displayed following
<recvDataMode> value
<sourceIP>
string
-
IP address of the source of data
<sourcePort>
string
-
IP port of the source of data
<dataLeft>
integer
-
number of bytes left in the UDP
datagram
Keepalive is available only on TCP connections.
For the behavior of #SL and #SLUDP in case of auto response mode or in
case of no auto response mode, see the description of the two commands.
AT#SCFGEXT?
Read command returns the current socket extended configuration parameters
values for all the six sockets, in the format: