LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1556 of 1904 2022-03-04
is elapsed and the DTR status is
equal to the value previously
specified, the #EVMONI executes
the AT command configured with
<paramType>=0.
<label>=ROAM, roaming monitoring.
<paramType> can assume only the value 0.
After roaming, the #EVMONI executes the AT command configured
with <paramType>=0.
<label>=CONTDEACT, context deactivation
<paramType> can assume only the value 0.
After the deactivation of all active contexts, the #EVMONI executes
the AT command configured with <paramType>=0.
<label>=RING, call ringing monitoring.
<paramType> can assume values in the range 0 - 1.
When <paramType>=1, <param> is
the number of call rings after which
the event occurs. The event is
notified by the execution of the AT
command configured with
<paramType>=0.
To Next Page
Loading...
