Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1557 of 1904 2022-03-04
Not Subject to NDA
1÷50
:
numbers of call rings
<label>=STARTUP, module start-up monitoring.
<paramType> can assume only the value 0.
After module start-up, the #EVMONI executes the AT command
configured with <paramType>=0.
<label>=REGISTERED,
<paramType> can assume only the value 0.
When the module is started up, and the SMSs have been ordered in
the internal memory, the event under monitoring is the network
registration (to home network or in roaming). After registration, the
#EVMONI executes the AT command configured with
<paramType>=0
<label>=GPIO1, GPIO2, GPIO3, GPIO4, GPIO5 monitoring.
<paramType> can assume values in the range 0 - 3.
Name
Type
Default
Description
<param>
integer
1
When <paramType>=1, <param> is
the GPIO pin number to be
monitored. Supported range is from
1 to a value that depends on the
hardware.
Value:
1÷max
:
max depends on the hardware.
<param>
integer
0
When <paramType>=2, <param> is
the GPIO status value to monitor.

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English