Telit Wireless Solutions LE910C series - Page 1558

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1558 of 1904 2022-03-04
Not Subject to NDA
Values:
0
:
GPIO status LOW
1
:
GPIO status HIGH
<param>
integer
0
When <paramType>=3, <param> is
the time interval starting when GPIO
pin has the value specified with
<paramType>=2. When the interval
is elapsed and GPIO pin value is
equal to the value previously
specified, the #EVMONI executes
the AT command configured with
<paramType>=0.
Value:
0÷255
:
sec
<label>=ADCH1, ADC High Voltage monitoring.
<paramType> can assume values in the range 0 - 3.
Name
Type
Default
Description
<param>
integer
1
When <paramType>=1, <param> is
the ADC pin number to monitor.
Value:
1÷max
:
max dependes on the hardware.
<param>
integer
0
When <paramType>=2, <param> is
the ADC High voltage threshold to
monitor.
Value:
0÷2000
:
Expressed in mV