Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1559 of 1904 2022-03-04
Not Subject to NDA
<param>
integer
0
When <paramType>=3, <param> is
the time interval starting when the
selected ADC pin (<paramType>=1)
goes above the threshold specified
with <paramType>=2. When the
interval is elapsed and the ADC pin
level is above the previously
specified threshold, the #EVMONI
executes the AT command
configured with <paramType>=0.
Value:
0÷255
:
Expressed in sec
<label>=ADCL1, ADC Low Voltage monitoring.
<paramType> can assume values in the range 0 - 3.
Name
Type
Default
Description
<param>
integer
0
When <paramType> = 1, <param> is
the ADC pin number to monitor.
Value:
1÷max
:
max dependes on the hardware.
<param>
integer
0
When <paramType> = 2, <param> is
the ADC Low voltage threshold to
monitor.
Value:
0÷2000
:
Expressed mV
<param>
integer
0
When <paramType>=3, <param> is
the time interval starting when the
selected ADC pin (<paramType>=1)
goes below the threshold specified
with <paramType>=2. When the

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English