Telit Wireless Solutions LE910C series - Page 1561

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1561 of 1904 2022-03-04
Not Subject to NDA
500÷5000
:
Expressed in msec
<label>=SMSIN, monitoring on incoming SMS.
<paramType> can assume values in the range 0 - 1.
Name
Type
Default
Description
<param>
string
-
When <paramType>=1, <param>
contains the text string that must be
received in an incoming SMS to
create the event. In this case,
#EVMONI executes the AT command
configured with <paramType>=0. The
maximum number of characters in
the SMS text string is 15.
If no text is specified in<param>
(empty string), each incoming SMS
triggers the event and #EVMONI
executes the AT command configured
with <paramType>=0.
<label>=CONSUME1, CONSUME2, CONSUME3, CONSUME4,
CONSUME5 used to define an action to be used in consume
functionality, see #CONSUMECFG command.
<paramType> can assume only values 0.
When the action identified by the <action_id> parameter of the
#CONSUMECFG command occurs, the #EVMONI executes the AT
command configured with <paramType>=0.
The DTMF string monitoring is available only if the DTMF decode
has been enabled (see #DTMF command)