Waveform generator (Option R&S RTO6-B6)
R&S
®
RT
O6
1015User Manual 1801.6687.02 ─ 05
●
Chapter 15.1.2, "Function generator", on page 1015
●
Chapter 15.1.3, "Modulation", on page 1020
●
Chapter 15.1.4, "Sweep", on page
1026
●
Chapter 15.1.5, "Arbitrary"
, on page 1027
Remote command:
WGENerator<m>:SOURce on page 2443
Copy settings from Gen1/Gen2
Copies all settings from Gen1/Gen2 and applies them to Gen2/Gen1.
Remote command:
WGENerator<m>:ACOPy on page 2443
Preset Gen1/Gen2/Patt Gen
Sets the parameters of the generator to their default values. The settings of the gener-
ators are not affected by an instrument preset.They are also not stored in the user-
defined preset.
Remote command:
WGENerator<m>:PRESet on page 2443
PGENerator:PRESet on page 2457
Message
Displays relevant messages concerning the coupling and sync settings.
15.1.2 Function generator
The R&S RTO6 function generator can generate input signals during testing. These
signals can be used, for example, when testing circuits.
Function type
Selects the type of waveform to be generated for the function generator.
"Sine"
Generates a sine wave. You can set its Frequency and Period.
Setup of the waveform generator
To Next Page
Loading...
