R&S RTO6 - 24.15.5 Interval search conditions

Remote control commands
R&S
®
RTO6
1610User Manual 1801.6687.02 ─ 05
24.15.5 Interval search conditions
T
rigger level setting:
SEARch:TRIGger:LEVel[:VALue] on page 1607
SEARch:TRIGger:INTerval:SLOPe.................................................................................1610
SEARch:TRIGger:INTerval:DELTa..................................................................................1610
SEARch:TRIGger:INTerval:RANGe................................................................................1610
SEARch:TRIGger:INTerval:WIDTh................................................................................. 1611
SEARch:TRIGger:INTerval:SLOPe <SearchName>,<Slope>
SEARch:TRIGger:INTerval:SLOPe? <SearchName>
Sets the edge for the search.
Parameters:
<Slope> POSitive | NEGative | EITHer
See Chapter 24.4.3, "Slope parameter", on page 1285
.
*RST
: POSitive
Parameters for setting and query:
<SearchName> String parameter, name of the search definition
Usage: Asynchronous command
SEARch:TRIGger:INTerval:DELTa <SearchName>,<WidthDelta>
SEARch:TRIGger:INTerval:DEL
Ta? <SearchName>
Defines a range around the "Interval width" value (see SEARch:TRIGger:
INTerval:WIDTh on page 1611).
Parameters:
<WidthDelta> Range: 0 to 10
Increment: 100E-9
*RST: 0
Default unit: s
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
SEARch:TRIGger:INTerval:RANGe <SearchName>,<RangeMode>
SEARch:TRIGger:INTerval:RANGe
? <SearchName>
Selects how the range of an interval is defined based on the interval width and delta
(see SEARch:TRIGger:INTerval:WIDTh on page 1611 and SEARch:TRIGger:
INTerval:DELTa on page 1610).
Parameters:
<RangeMode> WITHin | OUTSide | SHORter | LONGer
Search