Power analysis (option R&S RTO6-K31)
R&S
®
RT
O6
1127User Manual 1801.6687.02 ─ 05
"Apply"
Writes the result of the auto deskew to the "Skew offset" of the
selected channel.
Remote command:
POWer:DESKew:CURRent
on page 2521
Activate user defined preset
If enabled, the deskew values are written to a user-defined preset file, and the user-
defined preset is enabled. Thus, the probe setup and deskew values are not influenced
by a manual [Preset].
See also: Chapter 4.6, "Preset setup", on page 98.
Remote command:
POWer:DESKew:UDPReset on page 2521
Auto Deskew
Starts an auto deskew.
Make sure that the probes are configured correctly before you start the deskewing.
Remote command:
POWer:DESKew:EXECute on page 2521
19.1.1.2 DUT
Access: "Analysis" > "Power" > "DUT".
In this dialog, you can describe your device under test (DUT). The information set in
this dialog can be used on the title page for a report generated from the "Power Analy-
sis" measurements, see "Content" on page 1132.
Power measurement selection
To Next Page
Loading...
