Remote control commands
R&S
®
RTO6
1878User Manual 1801.6687.02 ─ 05
TRIGger<m>:FLXRay:HCRCerror <CRCHeaderError>
T
riggers on error in the Cyclic Redundancy Check of the header data (mainly frame ID
and payload length).
Parameters:
<CRCHeaderError>
ON | OFF
*RST: ON
TRIGger<m>:FLXRay:PCRCerror <CRCPayloadError>
Triggers on error in the Cyclic Redundancy Check of the payload data.
Parameters:
<CRCPayloadError>
ON | OFF
*RST: ON
24.17.10.3 Decode results
To load and acivate a label list, use:
●
BUS<m>:
NEWList on page 1672
●
BUS<m>:SYMBols on page 1672
To show the results on the screen, use the following commands:
●
BUS<m>:RESult on page 1671
BUS<m>:FLXRay:FCOunt?.......................................................................................... 1878
BUS<m>:FLXRay:FRAMe<n>:STATus?......................................................................... 1879
BUS<m>:FLXRay:FRAMe<n>:STARt?........................................................................... 1879
BUS<m>:FLXRay:FRAMe<n>:STOP?............................................................................1879
BUS<m>:FLXRay:FRAMe<n>:SYMBol?.........................................................................1880
BUS<m>:FLXRay:FRAMe<n>:TYPE?............................................................................1880
BUS<m>:FLXRay:FRAMe<n>:DATA?............................................................................ 1880
BUS<m>:FLXRay:FRAMe<n>:FLAGs?.......................................................................... 1881
BUS<m>:FLXRay:FRAMe<n>:ADID?.............................................................................1881
BUS<m>:FLXRay:FRAMe<n>:PAYLength?.................................................................... 1882
BUS<m>:FLXRay:FRAMe<n>:CYCount?....................................................................... 1882
BUS<m>:FLXRay:FRAMe<n>:CSSTate?........................................................................1882
BUS<m>:FLXRay:FRAMe<n>:CSValue?........................................................................1883
BUS<m>:FLXRay:FRAMe<n>:FCSTate?........................................................................1883
BUS<m>:FLXRay:FRAMe<n>:FCValue?........................................................................ 1883
BUS<m>:FLXRay:FCOunt?
Returns the number of decoded frames.
Suffix:
<m>
.
1..4
Selects the serial bus.
Protocols
To Next Page
Loading...
