Network operation and remote control
R&S
®
RTO6
1251User Manual 1801.6687.02 ─ 05
STATus:QUEStionable:DEEMbedding register
Table 22-8: Bits in the STATus:QUEStionable:DEEMbedding register
Bit No. Meaning
0
1
2
3
Warning for channel 1, 2, 3, 4 accordingly. The bits are set if there are problems in the deem-
bedding configuration of the assigned channel.
4
5
6
7
Error for channel 1, 2, 3, 4 accordingly. The bits are set if the deembedding configuration of the
assigned channel causes an error
.
8
9
10
11
W
arning for channel 1, 2, 3, 4 accordingly. The bits are set if there are problems in the probe
deembedding of the assigned channel.
12
13
14
15
Error for channel 1, 2, 3, 4 accordingly. The bits are set if the probe deembedding of the
assigned channel causes an error.
STATus:QUEStionable:LIMit, STATus:QUEStionable:MARGin registers
These registers contain information about the observance of the limits or margins of
measurements.
The LIMit bit is set if the limit of the assigned measurement is violated. The MARGin bit
is set if the margin of the assigned measurement is violated but not the limit (the limit
bit is not set).
The status bits are set if the limits or margins of one or more assigned measurements
are violated.
If multiple measurements are active, all measurement results af
fect the status bits.
Statistical results do not change the status bits.
T
able 22-9: Bits in the STATus:QUEStionable:LIMit and STATus:QUEStionable.MARGin registers
Bit No. Meaning
0
MEAS1
1
MEAS2
2
MEAS3
3
MEAS4
4
MEAS5
5
MEAS6
Remote control
To Next Page
Loading...
