Measurements
R&S
®
RTO6
291User Manual 1801.6687.02 ─ 05
Envelope selection 1|2
Envelope selection is ef
fective under the following conditions:
●
The waveform arithmetic of the cursor source waveform is set to envelope wave-
form (see
"Arithmetic" on page 130)
●
"Track waveform" is enabled.
●
Both horizontal and vertical cursors are enabled ("Type" = Both).
The setting defines which horizontal cursor is positioned to the maximum and which to
the minimum envelope values.
"Minimum"
The horizontal cursor is set to the crossing point of the vertical cursor
with the minimum waveform envelope.
"Maximum"
The horizontal cursor is set to the crossing point of the vertical cursor
with the maximum waveform envelope.
Remote command:
CURSor<m>:
X1ENvelope
on page 1474
CURSor<m>:X2ENvelope on page 1475
Track waveform
The horizontal cursors track the waveform. The first cursor line indicates the current
vertical minimum, and the second cursor line indicates the maximum. If the waveform
changes, e.g. during a running measurement, the cursors move along with it. If both
horizontal and vertical cursors are displayed, the horizontal cursors are positioned to
the crossing points of the vertical cursors with the waveform. The measurement results
are displayed in the "Cursor Results"
box.
Tracking disables the Y-coupling (coupling of horizontal cursor lines) and the Y user
position settings.
Remote command:
CURSor<m>:TRACking[:STATe] on page 1472
8.1.3.2 Advanced settings
Access: [Cursor] key > "Advanced" tab
The settings in the "Advanced" cursor tab configure the behavior and display of cursor
lines, and labels for the lines.
The cursor style and position of the measurement results is defined in the "Settings" >
"Appeareance" > "Cursor" dialog box. See Chapter 4.3.7, "Cursor appearance set-
tings", on page 85.
Cursor measurements
To Next Page
Loading...
