R&S RTO6 - 13.2.5 Search on decoded I²C data; 13.2.5.1 I²C search setup

Protocol analysis
R&S
®
RTO6
506User Manual 1801.6687.02 ─ 05
Column Description
Address type Address length, 7 bit or 10 bit
Address value (hex) Hexadecimal value of the address
Label Symbolic label name defined in the label list
R/W bit Value of the R/W bit
Bit rate Value of the bit rate
Table 13-3: Content of the Decode results table
Column Description
Formatted Value of all data bytes of the frame
Ack bit start Start time of the acknowledge bit
Ack bit Value of the address acknowledge bit
Tools
Press "Display settings" in the "Decode Results"
table to access the "Display" tab.
Remote commands
Remote commands are described in Chapter 24.17.3.3, "Decode results",
on page
1684.
13.2.5
Search on decoded I²C data
Using the search functionality, you can find various events in the decoded data, the
same events which you also can trigger on. Before you can start the search, you have
to configure the bus correctly and acquire decoded data.
To search on decoded data, set the search "Source" to the serial bus that is configured
for the protocol to be analyzed.
See also Chapter 11, "Search functions", on page 419.
13.2.5.1 I²C search setup
Access: [Bus] > "Shortcuts" tab > "Setup search"
I²C (option R&S R
T
O6-K510)