Protocol analysis
R&S
®
RTO6
890User Manual 1801.6687.02 ─ 05
"Data Max"
The second data pattern is required to specify a range with conditions
"In range" and
"Out of range".
Remote command:
SEARch:TRIGger:DPHY:
ESCMode:CONDition on page 2265
SEARch:TRIGger:DPHY:ESCMode:MAX on page 2265
SEARch:TRIGger:DPHY:ESCMode:MIN on page 2265
13.23.5.2 D-PHY search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 420
●
Chapter 11.4.2, "Display zoom settings", on page 440
Remote commands:
●
SEARch:RESult:DPHY:FCOunt? on page 2269
●
SEARch:RESult:DPHY:FRAMe<m>:CS? on page 2269
●
SEARch:RESult:DPHY:FRAMe<m>:DATA? on page 2270
●
SEARch:RESult:DPHY:FRAMe<m>:DTName? on page 2270
●
SEARch:RESult:DPHY:FRAMe<m>:DTYPe? on page 2270
●
SEARch:RESult:DPHY:FRAMe<m>:ECC? on page 2271
●
SEARch:RESult:DPHY:FRAMe<m>:PACKet<n>:IDX? on page 2271
●
SEARch:RESult:DPHY:FRAMe<m>:PACKet<n>:VALue? on page 2271
●
SEARch:RESult:DPHY:FRAMe<m>:STARt? on page 2272
●
SEARch:RESult:DPHY:FRAMe<m>:STATe? on page 2272
●
SEARch:RESult:DPHY:FRAMe<m>:STOP? on page 2272
●
SEARch:RESult:DPHY:FRAMe<m>:TYPE? on page 2273
●
SEARch:RESult:DPHY:FRAMe<m>:VCHannel? on page 2273
13.23.5.3 Searching D-PHY
Prerequisite: A serial bus is configured for the D-PHY signal to be decoded and ana-
lyzed.
The search for events is set up in the following way:
1. Press the [Bus] key and selet the "Shortcuts" tab.
2. Tap "Setup search".
3. If the dialog box does not contain a search entry, tap the "Add" icon to create one,
as described in "To create a user-defined search" on page 434.
D-PHY (option R&S R
T
O6-K580)
To Next Page
Loading...
