R&S RTO6 - 24.15.15 Search gate settings

Remote control commands
R&S
®
RTO6
1631User Manual 1801.6687.02 ─ 05
Parameters:
<Value> Range: 0 to 100
Increment: 1
*RST: 5
Default unit: dB
Usage: Asynchronous command
CURSor<m>:THReshold <Value>
Defines an absolute threshold as an additional condition for the peak search. Only
peaks that exceed the threshold are detected.
Suffix:
<m>
.
The suffix is irrelevant.
Parameters:
<V
alue> Threshold in dBm
Usage: Asynchronous command
Firmware/software: Version 2.70
24.15.15 Search gate settings
SEARch:GA
TE[:ST
ATe].................................................................................................1631
SEARch:GATE:MODE..................................................................................................1632
SEARch:GATE:SHOW..................................................................................................1632
SEARch:GATE:ABSolute:STARt....................................................................................1632
SEARch:GATE:ABSolute:STOP.................................................................................... 1632
SEARch:GATE:RELative:STARt.................................................................................... 1633
SEARch:GATE:RELative:STOP.....................................................................................1633
SEARch:GATE:ZCOupling............................................................................................ 1633
SEARch:GATE:ZDIagram............................................................................................. 1634
SEARch:GATE[:STATe] <SearchName>,<State>
SEARch:GATE[:STATe]? <SearchName>
Performs the search only on the defined gate area of the source waveform.
Parameters:
<State> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
Search