R&S RTO6 - 7.2.2.3 Vertical

Waveform analysis
R&S
®
RTO6
254User Manual 1801.6687.02 ─ 05
Restore Settings
Resets the time scale and the reference point to the original values of the reference
waveform.
Remote command:
REFCurve<m>:
RESTore
on page 1449
7.2.2.3 Vertical
Access: [Ref] key > "Vertical" tab
Mode
Selects the type of vertical settings:
"Coupled to
source"
Vertical position and scale of the source are used.
"Independent"
Scaling and position can be set specific to the reference waveform.
Remote command:
REFCurve<m>:VMODe on page
1449
Set to original
Restores the original vertical settings of the reference waveform (vertical scale, posi-
tion, and offset), if vertical scaling is set to "Independent".
Remote command:
REFCurve<m>:TOORignal on page 1450
Scale
Sets the vertical scale for the reference waveform, if vertical scaling is set to "Inde-
pendent". You can also use the vertical [Scale] knob to adjust this value.
Remote command:
REFCurve<m>:SCALe on page 1449
Position
Moves the reference waveform up or down in the diagram, if vertical scaling is set to
"Independent". If "Position" is assigned to the vertical [Position] knob, you can also use
this knob to adjust the "Vertical position"
Remote command:
REFCurve<m>:POSition on page 1450
Reference waveforms