Remote control commands
R&S
®
RTO6
1301User Manual 1801.6687.02 ─ 05
DISPlay:DIAGram:FINegrid <ShowFineScale>
If ON, the crosshair is displayed as a ruler with scale markers. If OFF
, the crosshair is
shown as dashed lines.
Parameters:
<ShowFineScale>
ON | OFF
Usage: Asynchronous command
DISPlay:DIAGram:CROSshair <Crosshair>
If selected, a crosshair is displayed in the diagram area. A crosshair allows you to
select a specific data point by its co-ordinates.
Parameters:
<Crosshair> ON | OFF
Usage: Asynchronous command
DISPlay:DIAGram:YFIXed <YGridFixed>
If enabled, the horizontal grid lines remain in their position when the position of the
curve is changed. Only the values at the grid lines are adapted. This reflects the
behavior of traditional oscilloscopes.
Parameters:
<YGridFixed> ON | OFF
Usage: Asynchronous command
DISPlay:DIAGram:XFIXed <XGridFixed>
If enabled, the vertical grid lines remain in their position when the horizontal position is
changed. Only the values at the grid lines are adapted.
Parameters:
<XGridFixed> ON | OFF
*RST: OFF
Usage: Asynchronous command
24.7.2.4 Smartgrid
The following LAYout commands configure the SmartGrid: add and remove diagrams,
and assign signals to the diagrams. In manual operation, you configure the SmartGrid
by drag and drop.
Instrument setup
To Next Page
Loading...
