Remote control commands
R&S
®
RTO6
1743User Manual 1801.6687.02 ─ 05
Parameters:
<FrameOffsetTDM> Range: 0 to 256
Increment: 1
*RST: 0
Default unit: bit
BUS<m>:I2S:CHANnel:LENGth <ChlgthTDM>
Sets the number of bits in a TDM channel block.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<ChlgthTDM> Range: 4 to 32
Increment: 4
*RST: 8
Default unit: bit
24.17.6.2 Trigger
The trigger suf
fix <m> is always 1 and can be omitted. It selects the trigger event: Only
the A-trigger is available for triggering on serial buses.
To trigger on a serial bus, make sure that:
●
TRIGger<m>:SOURce[:SELect] is set to SBUS.
●
The sources of the serial bus are channel signals: use BUS<m>:...:SOURce
commands.
●
Decoding is enabled: BUS<m>[:STATe] is set to ON.
TRIGger<m>:I2S:TYPE................................................................................................ 1743
TRIGger<m>:I2S:TCONdition<n>:CHANnel....................................................................1744
TRIGger<m>:I2S:TCONdition<n>:CONDtion...................................................................1745
TRIGger<m>:I2S:TCONdition<n>:DMIN.........................................................................1746
TRIGger<m>:I2S:TCONdition<n>:DMAX........................................................................1746
TRIGger<m>:I2S:SOWords...........................................................................................1746
TRIGger<m>:I2S:WSSLope.......................................................................................... 1747
TRIGger<m>:I2S:TYPE <Type>
Selects the trigger type for audio signal analysis.
Parameters:
<Type> DATA | WINDow | CONDition | WSELect | ECONdition
Protocols
To Next Page
Loading...
