Remote control commands
R&S
®
RTO6
1983User Manual 1801.6687.02 ─ 05
24.17.14.1 Configuration
BUS<m>:ARINc:SOURce.............................................................................................
1983
BUS<m>:ARINc:BR
Value............................................................................................. 1983
BUS<m>:ARINc:BRMode............................................................................................. 1983
BUS<m>:ARINc:MAXGap:SELect................................................................................. 1984
BUS<m>:ARINc:MAXGap:BITS.....................................................................................1984
BUS<m>:ARINc:MINGap:SELect...................................................................................1984
BUS<m>:ARINc:MINGap:BITS......................................................................................1984
BUS<m>:ARINc:POLarity............................................................................................. 1985
BUS<m>:ARINc:PRESet.............................................................................................. 1985
BUS<m>:ARINc:THReshold:HIGH.................................................................................1985
BUS<m>:ARINc:THReshold:LOW................................................................................. 1985
BUS<m>:ARINc:SOURce <SourceData>
Sets the channel for the signal source.
Reference and math waveforms are only available if the trigger source is one of the
input channels but not the serial bus.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<SourceData> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 |
R1 | R2 | R3 |
R4
*RST: C1W1
BUS<m>:ARINc:BRValue <BitRateValue>
Sets the number of transmitted bits per second.
Suffix:
<m>
.
1..4
Parameters:
<BitRateV
alue> Range: 10000 to 110000
Increment: 100
*RST: 100000
Default unit: bps
BUS<m>:ARINc:BRMode <BitRateMode>
Sets the bit rate mode to high or low speed.
Suffix:
<m>
.
1..4
Protocols