Remote control commands
R&S
®
RTO6
2485User Manual 1801.6687.02 ─ 05
"Advanced Jitter" dialog box. For remote operation, they are indicated by the suffix
ADVJitter<m>.
Remote control: ADVJitter suffix <m> Manual operation: "JA" subtab
1 to 2 correspond to "JA1" to "JA2"
● Signal.................................................................................................................. 2485
● Results
................................................................................................................ 2492
● Advanced settings...............................................................................................2507
24.22.2.1 Signal
ADVJitter<m>:SIGNal:TYPE......................................................................................... 2485
ADVJitter<m>:SIGNal:SOURce..................................................................................... 2486
ADVJitter<m>:SIGNal:QUICkmeas................................................................................ 2486
ADVJitter<m>:SIGNal:BITRate......................................................................................2486
ADVJitter<m>:SIGNal:CDRMode...................................................................................2486
ADVJitter<m>:SIGNal:REFSource................................................................................. 2486
ADVJitter<m>:SIGNal:CLKSource................................................................................. 2487
ADVJitter<m>:SIGNal:EDGE.........................................................................................2487
ADVJitter<m>:SIGNal:CLEStimation..............................................................................2487
ADVJitter<m>:SIGNal:CLFFactor...................................................................................2487
ADVJitter<m>:SIGNal:CFEStimation..............................................................................2488
ADVJitter<m>:SIGNal:CLFRequency............................................................................. 2488
ADVJitter<m>:SIGNal:CLOFfset....................................................................................2488
ADVJitter<m>:SIGNal:DATRate?...................................................................................2488
ADVJitter<m>:SIGNal:SAMTime....................................................................................2489
ADVJitter<m>:SIGNal:GATE:COUPling..........................................................................2489
ADVJitter<m>:SIGNal:GATE:CURSor............................................................................ 2489
ADVJitter<m>:SIGNal:GATE:RANGe:ABSolute:STARt.....................................................2489
ADVJitter<m>:SIGNal:GATE:RANGe:ABSolute:STOP..................................................... 2490
ADVJitter<m>:SIGNal:GATE:RANGe:MODE...................................................................2490
ADVJitter<m>:SIGNal:GATE:RANGe:RELative:STARt.....................................................2490
ADVJitter<m>:SIGNal:GATE:RANGe:RELative:STOP......................................................2490
ADVJitter<m>:SIGNal:GATE:ZDIagram..........................................................................2491
ADVJitter<m>:SIGNal:GATE:STATe............................................................................... 2491
ADVJitter<m>:SIGNal:SERStandard..............................................................................2491
ADVJitter<m>:SIGNal:TYPE <SignalType>
Select, if the analyzed signal is a data or clock signal.
Suffix:
<m>
.
1..2
Parameters:
<SignalType> CLOCk | DATNrz
*RST: DATNrz
Jitter analysis and clock data recovery
To Next Page
Loading...
