Remote control commands
R&S
®
RTO6
1499User Manual 1801.6687.02 ─ 05
MEASurement<m>:AMPTime:LCHeck<n>:LOWer:LIMit <LowerLimit>
MEASurement<m>:
AMPT
ime:LCHeck<n>:UPPer:LIMit <UpperLimit>
Define the lower and upper limit for limit checking, respectiveley. The valid range is
defined using the MEASurement<m>:AMPTime:LCHeck<n>:VALid command.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
<n> 1..50
Number of the amplitude/time measurement, see Table 24-6.
Parameters:
<UpperLimit>
Range: -100 to 100
Increment: 10E-6
*RST: 0
Usage: Asynchronous command
MEASurement<m>:AMPTime:LCHeck<n>:LOWer:MARGin <LowerMargin>
MEASurement<m>:AMPT
ime:LCHeck<n>:UPPer:MARGin <UpperMargin>
Define the lower and upper margins for the limit check, respectively. Margins are not as
strict as limits and must be within the valid value range. The valid range is defined
using the MEASurement<m>:AMPTime:LCHeck<n>:VALid command.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
<n> 1..50
Number of the amplitude/time measurement type, see
Table 24-6.
Parameters:
<UpperMargin>
Range: -100 to 100
Increment: 10E-6
*RST: 0
Usage: Asynchronous command
24.12.4 Arithmetic for amplitude/time and spectrum measurements
MEASurement<m>:AMPTime:ARIThmetic:CONStant
...................................................... 1500
MEASurement<m>:AMPTime:ARIThmetic:COUNit..........................................................1500
MEASurement<m>:AMPTime:ARIThmetic:CUNState...................................................... 1501
MEASurement<m>:AMPTime:ARIThmetic:CUUNit.......................................................... 1501
MEASurement<m>:AMPTime:ARIThmetic:CUUState...................................................... 1502
MEASurement<m>:AMPTime:ARIThmetic:OPERator...................................................... 1502
MEASurement<m>:AMPTime:ARIThmetic:PARameter<n>:AMPTime................................1502
Automatic measurements
To Next Page
Loading...
