Mask testing
R&S
®
RTO6
407User Manual 1801.6687.02 ─ 05
Remote command:
MTESt:
ONViolation:
PRINt on page 1595
Save waveform ← Action on mask
Saves the waveform data to a file according to settings in "Menu" > "Save/Recall" >
"Save" tab > "Waveforms".
Remote command:
MTESt:ONViolation:SAVewaveform on page 1595
Trigger out pulse ← Action on mask
Sends a pulse to the [Trigger Out] connector on the rear panel.
You can adjust the pulse by tapping the settings icon, see "Trigger out signal setup"
on page 225.
Remote command:
MTESt:ONViolation:TRIGgerout on page 1596
Report ← Action on mask
Creates and saves a report using the settings.
Remote command:
MTESt:ONViolation:REPort on page 1596
Start Executable ← Action on mask
Starts an external application. Tap "Config Executable" to set the application path and
parameters.
Remote command:
MTESt:ONViolation:RUNexec on page 1596
10.2.4 Mask display
Access: [App Cockpit] > "Analysis" tab > "Mask" > "Display".
In this dialog, you can reset the mask results and display the mask.
Show mask
Switches the display of all mask segments on or off.
Remote command:
MTESt:
SHOW on page 1583
Mask test settings
To Next Page
Loading...
