Remote control commands
R&S
®
RTO6
1808User Manual 1801.6687.02 ─ 05
TRIGger<m>:CAN:FDATa:SCERror <Stuf
fCountError>
T
riggers on stuff count errors. A stuff count error occurs if th received stuff count value
does not match the value calculated from the own stuff bit count.
The trigger type TRIGger<m>:CAN:TYPE must be set to ERRC.
Only relevant for CAN FD signals in ISO standard.
Parameters:
<StuffCountError> ON | OFF
*RST: ON
24.17.8.3 Decode results
To load and acivate a label list, use:
●
BUS<m>:
NEWList on page 1672
●
BUS<m>:SYMBols on page 1672
BUS<m>:CAN:FCOunt?............................................................................................... 1808
BUS<m>:CAN:FDATa:FRAMe<n>:STANdard?................................................................1809
BUS<m>:CAN:FRAMe<n>:STATus?.............................................................................. 1809
BUS<m>:CAN:FRAMe<n>:NDBYtes?............................................................................1810
BUS<m>:CAN:FRAMe<n>:STARt?................................................................................1810
BUS<m>:CAN:FRAMe<n>:STOP?................................................................................ 1810
BUS<m>:CAN:FRAMe<n>:SYMBol?..............................................................................1811
BUS<m>:CAN:FRAMe<n>:TYPE?.................................................................................1811
BUS<m>:CAN:FRAMe<n>:DATA?................................................................................. 1811
BUS<m>:CAN:FRAMe<n>:ACKState?...........................................................................1812
BUS<m>:CAN:FRAMe<n>:CSSTate?............................................................................ 1812
BUS<m>:CAN:FRAMe<n>:DLCState?........................................................................... 1812
BUS<m>:CAN:FRAMe<n>:IDSTate?..............................................................................1812
BUS<m>:CAN:FRAMe<n>:ACKValue?.......................................................................... 1812
BUS<m>:CAN:FRAMe<n>:BITRate?............................................................................. 1813
BUS<m>:CAN:FRAMe<n>:CSValue?.............................................................................1813
BUS<m>:CAN:FRAMe<n>:DLCValue?...........................................................................1813
BUS<m>:CAN:FRAMe<n>:IDTYpe?.............................................................................. 1814
BUS<m>:CAN:FRAMe<n>:IDValue?..............................................................................1814
BUS<m>:CAN:FRAMe<n>:BSEPosition?....................................................................... 1815
BUS<m>:CAN:FRAMe<n>:FERCause?......................................................................... 1815
BUS<m>:CAN:FRAMe<n>:SDEXport?...........................................................................1815
BUS<m>:CAN:FDATa:FRAMe<n>:SCValue?.................................................................. 1816
BUS<m>:CAN:FRAMe<n>:BYTE<o>:STATe?.................................................................1816
BUS<m>:CAN:FRAMe<n>:BYTE<o>:VALue?.................................................................1816
BUS<m>:CAN:FCOunt?
Returns the number of decoded frames of the acquisition.
Protocols
To Next Page
Loading...
