R&S RTO6 - 24.11.2 Cursor results

Remote control commands
R&S
®
RTO6
1476User Manual 1801.6687.02 ─ 05
CURSor<m>:LABel:Y<1..2> <Name>
Defines a label to be displayed with the vertical cursors. Y1 is the lower cursor line,
and Y2 the upper one.By default, the cursors are labeled as Cu1.Y1, Cu1.Y2, Cu2.Y1,
Cu2.Y2, Cu3.Y1, Cu3.Y2, Cu4.Y1, Cu4.Y2.
Suffix:
<m>
.
1..4
Selects the cursor set.
Parameters:
<Name> String with the cursor label
Usage: Asynchronous command
CURSor<m>:SIAD <ShwInAllDiags>
Shows the enabled cursor measurements in all active diagrams of the same domain
(time/ spectrum).
Suffix:
<m>
.
1..*
The suffix is irrelevant. All cursor measurements are af
fected.
Parameters:
<ShowInAllDiagr> ON | OFF
*RST: ON
Usage: Asynchronous command
24.11.2 Cursor results
CURSor<m>:XDELta[:VALue]?
......................................................................................1476
CURSor<m>:XDELta:INVerse?..................................................................................... 1477
CURSor<m>:YDELta[:VALue]?......................................................................................1477
CURSor<m>:YDELta:SLOPe........................................................................................ 1477
CURSor<m>:XDELta[:VALue]?
Queries the delta value (distance) of two vertical cursor lines.
Suffix:
<m>
.
1..4
Selects the cursor set.
Return values:
<Delta> Range: -100E+24 to 100E+24
*RST: 0
Default unit: s
Usage: Query only
Asynchronous command
Cursor measurements