R&S RTO6 - 24.9.19 Trigger control

Remote control commands
R&S
®
RTO6
1429User Manual 1801.6687.02 ─ 05
Suffix:
<m>
.
1..3
Irrelevant, omit the suf
fix.
Parameters:
<EnabRstEvt>
ON | OFF
*RST: OFF
Usage: Asynchronous command
TRIGger<m>:SEQuence:RESet:TIMeout[:ENABle] <State>
If set to ON, the instrument waits for the time defined using TRIGger<m>:
SEQuence:
RESet:
TIMeout:TIME for the specified number of B-events. If no trigger occurs dur-
ing that time, the sequence is restarted with the A-event.
Suffix:
<m>
.
1..3
Irrelevant, omit the suffix.
Parameters:
<State> ON |
OFF
*RST: OFF
Usage: Asynchronous command
TRIGger<m>:SEQuence:RESet:TIMeout:TIME <ResetTimeout>
The time the instrument waits for the number of B-events specified using
TRIGger<m>:
SEQuence:COUNt before the sequence is restarted with the A-event.
Suffix:
<m>
.
1..3
Irrelevant, omit the suffix.
Parameters:
<ResetT
imeout> Range: 0 to 50
Increment: 1E-12
*RST: 0
Default unit: s
Usage: Asynchronous command
24.9.19 Trigger control
TRIGger<m>:MODE.....................................................................................................1430
TRIGger<m>:FORCe................................................................................................... 1430
TRIGger<m>:OUT:POLarity.......................................................................................... 1430
TRIGger<m>:OUT:PLENgth.......................................................................................... 1431
TRIGger<m>:OUT:DELay............................................................................................. 1431
Trigger