R&S RTO6 - 15.4 Coupling settings

Waveform generator (Option R&S RTO6-B6)
R&S
®
RT
O6
1038User Manual 1801.6687.02 ─ 05
Remote command:
GENerator:
ALIGnment:
DC:RESult:DATE? on page 2461
Time
Displays the time of the last performed DC offset alignment.
Remote command:
GENerator:ALIGnment:DC:RESult:TIME? on page 2461
Overall alignment state
Displays the result of the DC offset alignment.
Remote command:
GENerator:ALIGnment:DC:RESult[:STATe]? on page 2461
15.4 Coupling settings
Access: [Gen] > "Coupling"
In the R&S R
TO6, you can couple certain settings of the available waveform genera-
tors. If one of the available coupling options is enabled for one of the generators, then
you cannot change the coupled parameters at the "Setup" tab of the other generator.
The values for all coupled parameters are automatically taken from the currently
selected generator.
Generator enable
Enables the coupling of the generators, with the selected set of parameters: amplitude,
frequency and noise.
Remote command:
WGENerator<m>:
COUPling:
STATe on page 2462
Coupling settings