R&S RTO6 - 24.12.8 Histograms; 24.12.8.1 Histogram display

Remote control commands
R&S
®
RTO6
1521User Manual 1801.6687.02 ─ 05
<n> 1..2
Parameters:
<ValidRange> ILIMit | ULIMit | LLIMit | OLIMit
ILIMit: Inside (within) limit; between the upper and lower limit
values
ULIMit: Upper limit; above the upper limit value
LLIMit : Lower limit; below the lower limit value
OLIMit: Outside limit; above the upper limit or below the lower
limit values
*RST
: ILIMit
Usage: Asynchronous command
24.12.8 Histograms
See also: Chapter 24.16.5, "W
aveform histogram export to file",
on page 1656.
● Histogram display................................................................................................1521
● Histogram measurement.....................................................................................1527
24.12.8.1 Histogram display
LAYout:HISTogram:ADD............................................................................................... 1521
LAYout:HISTogram:ENABle...........................................................................................1522
LAYout:HISTogram:SOURce......................................................................................... 1523
LAYout:HISTogram:MODE............................................................................................ 1523
LAYout:HISTogram:HORZ:MODE.................................................................................. 1524
LAYout:HISTogram:HORZ:ABSolute:STARt.................................................................... 1524
LAYout:HISTogram:HORZ:ABSolute:STOP.....................................................................1524
LAYout:HISTogram:HORZ:RELative:STARt.....................................................................1525
LAYout:HISTogram:HORZ:RELative:STOP..................................................................... 1525
LAYout:HISTogram:VERTical:MODE.............................................................................. 1525
LAYout:HISTogram:VERTical:ABSolute:STARt................................................................ 1526
LAYout:HISTogram:VERTical:ABSolute:STOP.................................................................1526
LAYout:HISTogram:VERTical:RELative:STARt.................................................................1526
LAYout:HISTogram:VERTical:RELative:STOP................................................................. 1526
LAYout:HISTogram:RESet.............................................................................................1527
LAYout:HISTogram:REMove..........................................................................................1527
LAYout:HISTogram:ADD <HistogramName>, <Source>, <XStart>, <XStop>,
<YStart>, <YStop>, <Relative>, <Orientation>
Defines and displays a new histogram for the specified source.
Note: To define the mode of the histogram (vertical or horizontal), use the LAYout:
HISTogram:MODE command.
For numerical values, the input of a unit is not supported for this command.
Automatic measurements