R&S RTO6 - Page 1524

Remote control commands
R&S
®
RTO6
1524User Manual 1801.6687.02 ─ 05
*RST: VERTical
Parameters for setting and query:
<HistogramName> The name of the histogram as defined using LAYout:
HISTogram:ADD
on page 1521.
Usage: Asynchronous command
LAYout:HISTogram:HORZ:MODE <HistogramName>,<Mode>
LAY
out:HISTogram:HORZ:MODE? <HistogramName>
Defines or queries whether the value range limits are entered as absolute or relative
values.
Parameters:
<Mode> ABS | REL
*RST: ABS
Parameters for setting and query:
<HistogramName>
Usage: Asynchronous command
LAYout:HISTogram:HORZ:ABSolute:STARt <HistogramName>,<Start>
LAYout:HISTogram:HORZ:ABSolute:STARt? <HistogramName>
Defines the horizontal start value of the histogram.
For numerical values, the input of a unit is not supported for this command.
Parameters:
<Start> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0
Parameters for setting and query:
<HistogramName>
Usage: Asynchronous command
LAYout:HISTogram:HORZ:ABSolute:STOP <HistogramName>,<Stop>
LAY
out:HISTogram:HORZ:ABSolute:STOP? <HistogramName>
Defines the horizontal stop value of the histogram.
For numerical values, the input of a unit is not supported for this command.
Parameters:
<Stop> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0.01
Parameters for setting and query:
<HistogramName>
Automatic measurements