Search functions
R&S
®
RTO6
428User Manual 1801.6687.02 ─ 05
Range, Time
Set the timeout condition, see:
●
"Range" on page 203
●
"Time" on page 204
Remote command:
SEARch:TRIGger:TIMeout:RANGe on page 1616
SEARch:TRIGger:TIMeout:TIME on page 1616
Level
Sets the voltage level for trigger search. The value is used for all search event types
that require one trigger level. The search trigger level is search-specific, you can define
different levels in different searches for the same event.
Remote command:
SEARch:TRIGger:LEVel[:VALue] on page 1607
11.2.2.7 Interval
The interval search settings are the same as the interval trigger settings. To apply the
trigger settings to search, tap Copy from trigger A'.
The interval search is not available if the search source is a digital channel.
Search setup
To Next Page
Loading...
