Jitter analysis and clock data recovery
R&S
®
RTO6
1072User Manual 1801.6687.02 ─ 05
Active Measurements
The "Active Measurements" list shows the measurements that are selected in the
selected category
. At least, one measurement must be selected. If further settings are
available for a measurement, a settings icon is shown beside the measurement's
name.
To change the selection, tap "Add / Remove".
For details on the available measurements, see Chapter 18.1.1, "Jitter measurements",
on page 1069.
Remote command:
MEASurement<m>:MAIN on page 1483
MEASurement<m>:ADDitional on page 1484
18.1.2.2 Settings for clock measurements
The cycle-cycle measurements are intended to analyze the quality of clock signals.
They require a few additional settings for period and pulse width measurement. See
also: Table 18-1
► To configure a measurement, tap it in the "Active Measurements" list.
Jitter measurements (options R&S R
T
O6-K12/K13)
To Next Page
Loading...
