Protocol analysis
R&S
®
RTO6
879User Manual 1801.6687.02 ─ 05
"HS Burst Bits"
The filtered high-speed bits of each lane , including only bits that are
part of a burst.
"HS Burst Words"
8 bits per word in a high-speed burst of each lane.
"HS Merged
Bytes"
The words from the previous layer after they have been merged into
one honeycomb.
"HS Merged Words"
The bytes that are combined/split into words.
"LP Edges"
The combined edge display of DP0 and DN0.
"LP States"
The low-power states LP00, LP01, LP10, LP11 of DP0 and DN0.
Show multiple lanes
Enables the display of the results in multiple lanes.
Remote command:
BUS<m>:DPHY:SMLanes
on page 2248
13.23.2.3 Configuring the D-PHY signals
For configuration, assign the lines to the input channels and define the logical thresh-
olds and the hysteresis.
1. Press the [Bus]
key on the front panel.
2. Select the tab of the bus you want to set up, for example "SB1".
3. In the "Setup" tab, select the protocol: "D-PHY".
4. Tap the "Variant" button, and select the protocol.
5. Enter the number of "Data Lanes".
6. Select the source and type of "Probe", for each lane.
7. Enter the "HS threshold" and the "Hysteresis" for each data lane.
8. Enter the low-power thresholds.
9. Enable "Decode".
13.23.3 D-PHY trigger
13.23.3.1 D-PHY trigger settings
Access: [Bus] > "Shortcuts" tab > "Setup trigger"
D-PHY (option R&S RT
O6-K580)
To Next Page
Loading...
