R&S RTO6 - 24.8.7.6 Modular probes, deembedding

Remote control commands
R&S
®
RTO6
1358User Manual 1801.6687.02 ─ 05
Parameters:
<VoltageAdjust> Correction voltage
Range: -100E+24 to 100E+24
Increment: 1E-3
*RST: 0
Default unit: V
Usage: Asynchronous command
24.8.7.6 Modular probes, deembedding
The commands of this chapter are relevant for R&S RT‑ZM modular probes when used
for measurements on signal frequencies of 4 GHz and higher. The commands are
available in firmware version 4.00 and higher.
See also: PROBe<m>:SETup:PRMode on page 1354
PROBe<m>:DEEMbedding:PMODe...............................................................................1358
PROBe<m>:DEEMbedding:TIPModule[:SELect]............................................................. 1358
PROBe<m>:DEEMbedding:TIPModule:CSPFile..............................................................1359
PROBe<m>:DEEMbedding:TIPModule:ZMA<n>:SUBModule...........................................1359
PROBe<m>:DEEMbedding:BANDwidth..........................................................................1359
PROBe<m>:DEEMbedding:MODE................................................................................ 1360
PROBe<m>:DEEMbedding:REMProbeload.................................................................... 1360
PROBe<m>:DEEMbedding:LOAD:IMPedance................................................................1361
PROBe<m>:DEEMbedding:PMODe <MeasMode>
Suffix:
<m>
.
1..4
Parameters:
<MeasMode> DMODe | CMODe | PMODe | NMODe
See PROBe<m>:SETup:PRMode on page 1354.
*RST: DMODe
Usage: Asynchronous command
PROBe<m>:DEEMbedding:TIPModule[:SELect] <ProbeTip>
Selects the tip module that is used for measurement.
Suffix:
<m>
.
1..4
Selects the channel to which the probe is connected.
Parameters:
<ProbeTip> NONE | ZMA10 | ZMA12 | ZMA14 | ZMA15 | ZMA30 | ZMA40 |
ZMA50 | CUST
*RST: ZMA10
Usage: Asynchronous command
Acquisition and setup