R&S RTO6 - 24.9.14 TV;Video trigger

Remote control commands
R&S
®
RTO6
1412User Manual 1801.6687.02 ─ 05
Parameters:
<ClockLevel> Range: -10 to 10
Increment: 1E-3
*RST: 0
Default unit: V
Usage: Asynchronous command
TRIGger<m>:SPATtern:PATTern <Pattern>
The pattern contains the bits of the serial data to be found in the data stream. The
maximum length of the pattern is 128 bit.
Suffix:
<m>
.
1..3
Only 1 = A-trigger, 2 | 3 = not available. Can be omitted.
Parameters:
<Pattern> Numeric or string pattern, see Chapter 24.4.6, "Bit pattern
parameter", on page 1286. The string parameter accepts the bit
value X (don't care).
Usage: Asynchronous command
TRIGger<m>:SPATtern:REFSource <ReferenceSource>
Selects if an explicit clock or a CDR signal is used as a reference signal.
Suffix:
<m>
.
1..3
Parameters:
<ReferenceSource> CLOCk | CDR
*RST: CDR
Usage: Asynchronous command
24.9.14 TV/Video trigger
The TV or video trigger requires a channel input as trigger source (TRIGger<m>:
SOURce[:
SELect]). It is only available for the A-event (Suffix = 1).
Make sure to set the trigger level - the threshold of the sync pulse - with TRIGger<m>:
LEVel<n>[:VALue].
TRIGger<m>:TV:STANdard...........................................................................................1413
TRIGger<m>:TV:MODE................................................................................................1413
TRIGger<m>:TV:POLarity.............................................................................................1414
TRIGger<m>:TV:LINE.................................................................................................. 1414
TRIGger<m>:TV:LFIeld.................................................................................................1415
TRIGger<m>:TV:CUSTom:SCANmode...........................................................................1415
Trigger