R&S RTO6 - 4.3.6 Dialogs appearance settings

Instrument setup
R&S
®
RTO6
83User Manual 1801.6687.02 ─ 05
Font size
Defines the size of the labels in the diagram.
Remote command:
DISPlay:
SIGNal:LABel:
FONTsize on page 1308
Labels
For each waveform, the "Labels" table shows the defined labels with their visibility
state, label texts and positions. The labels belog to the selected waveform.
Enter the label text and the horizontal and vertical positions for each label. Enable
"State" to show the label on the screen. The individual state of the labels takes ef
fect if
"Show" is active.
"Add"
Adds a line at the end of the list.
"Copy"
Copies the selected line in a new line.
"Remove"
Deletes the selected line. Only single lines can be removed.
Y
ou can also delete a label by using the toolbar: T
ap the "Delete" icon
and then the label.
Remote command:
DISPlay:SIGNal:LABel:
ADD on page 1308
DISPlay:SIGNal:LABel:STATe on page 1311
DISPlay:SIGNal:LABel:IDSList on page 1310
DISPlay:SIGNal:LABel:REMove on page 1309
DISPlay:SIGNal:LABel:TEXT on page 1312
DISPlay:SIGNal:LABel:HORizontal:ABSolute:POSition on page 1312
DISPlay:SIGNal:LABel:VERTical:ABSolute:POSition on page 1312
DISPlay:SIGNal:LABel:HORizontal:RELative:POSition on page 1313
DISPlay:SIGNal:LABel:VERTical:RELative:POSition on page 1313
4.3.6 Dialogs appearance settings
Access: "Settings" > "Appearance" > "Dialogs" tab
Appearance settings