Remote control commands
R&S
®
RTO6
2359User Manual 1801.6687.02 ─ 05
Parameters:
<Snoop> ANY | YES | NO
*RST: ANY
TRIGger<m>:PCIE:TLP:SNUM <TLPSeqNo>
Sets the sequence numbe to be triggered on for the transaction layer type trigger.
Parameters:
<TLPSeqNo>
12-bit pattern, see Chapter 24.4.6, "Bit pattern parameter",
on page 1286. The string parameter accepts the bit value X
(don't care).
TRIGger<m>:PCIE:TLP:TCHN <Traf
ficClass>
Sets the traffic class to be triggered on for the transaction layer type trigger.
Parameters:
<TrafficClass> ANY | ZERO | ONE | TWO | THREE | FOUR | FIVE | SIX |
SEVEN
*RST: ANY
TRIGger<m>:PCIE:TLP:TYPE <Type>
Sets the transaction type to be triggered on for the transaction layer type trigger
.
Parameters:
<Type> ANY | MEM | IO | CFG | MSG | CPL | FETCH | SWAP | CAS
*RST: ANY
TRIGger<m>:PCIE:TYPE <Type>
Sets the trigger type for the PCI express analysis..
Parameters:
<T
ype> TLP | DLLP | ORD | ERR
*RST: TLP
24.17.27.4 Decode results
In all BUS<m>:PCIE:
RESult:PACKet<n> commands, the suffix <m> selects the
serial bus and the suffix <n> selects the frame number in the decode table.
BUS<m>:PCIE:RESult:PACKet<n>:ADDR?.................................................................... 2360
BUS<m>:PCIE:RESult:PACKet<n>:CPID?..................................................................... 2360
BUS<m>:PCIE:RESult:PACKet<n>:CPS?.......................................................................2360
BUS<m>:PCIE:RESult:PACKet<n>:DATA?.....................................................................2361
BUS<m>:PCIE:RESult:PACKet<n>:DFC?.......................................................................2361
BUS<m>:PCIE:RESult:PACKet<n>:FCOunt?..................................................................2362
Protocols
To Next Page
Loading...
