R&S RTO6 - Settings

Power analysis (option R&S RTO6-K31)
R&S
®
RT
O6
1125User Manual 1801.6687.02 ─ 05
Type, Name, Bandwidth
The fields show the characteristics of a recognized or predefined probe for information.
If the instrument cannot recognize the probe, and the probe is not known, the "T
ype" is
"None", and the other fields are empty.
Remote command:
PROBe<m>:SETup:TYPE? on page 1344
PROBe<m>:SETup:NAME? on page 1344
PROBe<m>:SETup:BANDwidth? on page 1345
Predefined probe, Vertical unit, Attenuation
Current probes R&S RT-ZCxx, the high-voltage active probe R&S RT-ZD01 and the
transmission line probe R&S RT-ZZ80 are not recognized automatically but the param-
eters of these probes are known to the instrument. Select the correct probe type and
enter additional parameters if necessary. The corresponding "Vertical unit" and the
"Attenuation" or "Gain" are set.
For an auto deskew, only Rohde & Schwarz probes are supported.
Settings
In this tab, you can define the preset behavior and how the auto deskew results are
stored.
Power measurement selection