R&S RTO6 - Filter

Remote control commands
R&S
®
RTO6
2414User Manual 1801.6687.02 ─ 05
Filter
EYE<m>:FIL
T
er:STATe................................................................................................. 2414
EYE<m>:FILTer:BPATtern:MODE.................................................................................. 2414
EYE<m>:FILTer:BPATtern:PREFix<1..8>........................................................................2415
EYE<m>:FILTer:BPATtern:CENTer.................................................................................2415
EYE<m>:FILTer:BPATtern:SUFFix<1..5>........................................................................ 2415
EYE<m>:FILTer:BPATtern:SLEFt................................................................................... 2415
EYE<m>:FILTer:BPATtern:SRIGht................................................................................. 2415
EYE<m>:FILTer:BPATtern:RESet...................................................................................2415
EYE<m>:FILTer:DDR:FTYPe.........................................................................................2415
EYE<m>:FILTer:DDR:LENerror..................................................................................... 2416
EYE<m>:FILTer:STATe <State>
Applies the filter settings to the data signal.
Suffix:
<m>
.
1..4
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
EYE<m>:FILTer:BPATtern:MODE <Mode>
Selects which bits contribute to the eye generation.
Suffix:
<m>
.
1..4
Parameters:
<Mode> ABITs | LTRansition | CLEVel | BPATtern
ABITs
All bits contribute to the eye diagram, same as EYE<m>:
FILTer:
STATe is OFF.
LTRansition
Level transition, only bits after a signal transition contribute (0 to
1, or 1 to 0).
CLEVel
Constant level, only bits without a preceding signal transition
contribute ( 0 to 0, or 1 to 1).
BPATtern
Only bits contribute that match the defined pattern before and
after the center eye.
*RST: ABITs
Usage: Asynchronous command
Protocols