Getting started
R&S
®
RTO6
52User Manual 1801.6687.02 ─ 05
3. To change the size of a diagram, tap the handle between two diagram frames and
drag it to the required position.
Remote commands: see Chapter 24.7.2.4, "Smartgrid", on page
1301.
3.3.6
Toolbar
The toolbar provides direct access to important control and measurement functions.
By default, the toolbar shows the most frequently used functions. You can configure the
content of the toolbar, see
Chapter 3.3.6.2, "Configuring the toolbar", on page 53.
3.3.6.1 Using the toolbar
Using the toolbar is easy and straightforward.
Some of the toolbar functions are one-click actions. These actions are performed
immediately when you tap the icon.
Other toolbar functions are analyzing functions. These functions are interactive actions.
To use analyzing functions (interactive actions)
1. If several waveforms are shown in the diagram, select the waveform that you want
to analyze.
See: "To select a waveform" on page 50
2. Tap the icon of the function in the toolbar.
If there are many functions on the toolbar, and not all icons are visible, scroll the
toolbar using the arrow on the right end of the toolbar.
3. Check and adjust the settings in the overlay menu.
Operating the instrument
To Next Page
Loading...
