Protocol analysis
R&S
®
RTO6
752User Manual 1801.6687.02 ─ 05
Remote commands
Remote commands to retrieve decode results are described in Chapter 24.17.17.3,
"Decode results", on page 2045
.
13.16.5
Search on decoded MDIO data
Using the search functionality, you can find various events in the decoded data. You
can find the same events that you can trigger on, and even many more, since several
event types can also be combined.
Before you can start the search, you have to configure the bus correctly and acquire
decoded data.
To search on decoded data, set the search source to "SerBus" for the configured proto-
col.
For general information on how to handle the search functionality, see Chapter 11,
"Search functions", on page 419.
If you need information on how to get started with searching MDIO data, see Chap-
ter 13.16.5.3, "Searching MDIO data", on page 754. Otherwise proceed with the
MDIO search setup.
13.16.5.1 MDIO search setup
Access: [Bus] > "Shortcuts" tab > "Setup search"
Search types
Selects the event types to be searched.
Available event types are "Frame Start", "Frame Stop", and "Data".
Only if search criteria type "Data" is selected, individual search parameters can be
specified in the tabs below the
"Search criteria" dialog. For these parameters, see "ST"
on page 753, "OP" on page 753, "PHYAD/PRTAD" on page 753, "REGAD/DEVAD"
on page 753, and "DATA/ADDRESS" on page 753.
Remote command:
SEARch:TRIGger:MDIO:TYPE on page 2051
MDIO (option R&S R
TO6-K540)
To Next Page
Loading...
