R&S RTO6 - 24.23.8 Dynamic ON resistance

Remote control commands
R&S
®
RTO6
2535User Manual 1801.6687.02 ─ 05
●
RMS: RMS value of the long-term measurement results
●
STDDev: standard deviation of the long-term measurement results
Query parameters:
<MeasType> FREQ | DUTY
Usage: Query only
POWer:MODulation:SOURce <Source>
Selects the source for the measurement.
Parameters:
<Source> CURRENT | VOLTAGE
*RST: VOLTAGE
POWer:MODulation:TYPE <AnalysisType>
Sets the type of measurement.
Parameters:
<AnalysisT
ype> TURNON | CONT
*RST: CONT
24.23.8 Dynamic ON resistance
POWer:DONRes:AUT
O................................................................................................2535
POWer:DONRes:AVG.................................................................................................. 2535
POWer:DONRes:EXECute............................................................................................2536
POWer:DONRes:GATE<m>:STARt................................................................................2536
POWer:DONRes:GATE<m>:STOP................................................................................ 2536
POWer:DONRes:REPort:ADD.......................................................................................2536
POWer:DONRes:RESult:RESistance?........................................................................... 2536
POWer:DONRes:AUTO <Autoscale>
Selects the scaling for the display of the results.
Parameters:
<Autoscale> AUTO | MANUAL
*RST: MANUAL
POWer:DONRes:AVG <A
verage>
Enables/disables averaging.
Parameters:
<A
verage> ON | OFF
*RST: ON
Power analysis (option R&S RT
O6-K31)