Remote control commands
R&S
®
RTO6
2069User Manual 1801.6687.02 ─ 05
Parameters:
<SSCError> ON | OFF
*RST: ON
TRIGger<m>:RFFE:ERRor:USEQuence <UnknownSequence>
Enables the trigger on an unknown sequence - when the instrument cannot detect any
supported command sequence.
Parameters:
<UnknownSequence>ON | OFF
*RST: ON
TRIGger<m>:RFFE:ERRor:GAP <GapError>
Enables the trigger on a gap error.
Parameters:
<GapError>
ON | OFF
*RST: ON
TRIGger<m>:RFFE:ERRor:VERSion <VersionError>
Enables the trigger on RFFE version error
.
Parameters:
<VersionError> ON | OFF
*RST: ON
TRIGger<m>:RFFE:INTerrupt <Interrupt>
Sets the interrupt pattern for the interupt summary and notification trigger type.
Parameters:
<Interrupt>
24.17.18.3 Decode results
In all BUS<m>:RFFE commands, the suffix <m> selects the serial bus. Suf
fix <n>
selects index of the command sequence.
To load and acivate a label list, use:
●
BUS<m>:NEWList on page 1672
●
BUS<m>:SYMBols on page 1672
BUS<m>:RFFE:FCOunt?..............................................................................................2070
BUS<m>:RFFE:SEQuence<n>:STATe?..........................................................................2070
BUS<m>:RFFE:SEQuence<n>:STARt?..........................................................................2071
BUS<m>:RFFE:SEQuence<n>:STOP?.......................................................................... 2071
Protocols
To Next Page
Loading...
