Instrument setup
R&S
®
RTO6
86User Manual 1801.6687.02 ─ 05
4.3.8 Measurement appearance settings
Access: "Settings" > "Appearance"
> "Measurement"
tab
Group results
If enabled, all results are shown in one result box (default).
If disabled, the results of each measurement group are shown in a separate result box.
The default position is ignored.
The setting affects all measurements except for the peak list.
Remote command:
MEASurement<m>:
DISPlay:GROuping on page 1315
Result position
Defines the default position of the result table, when a new measurement is started:
●
"Docked": fixed tab below the diagrams
●
"Preview": result icon on the signal bar
●
"Floating": floating result box in front of the diagrams
The setting affects only grouped results.
Remote command:
DISPlay:RESultboxes:MEPosition on page 1315
Show statistic columns
Select the statistical values that you want to see in the results table.
Appearance settings
To Next Page
Loading...
