Power analysis (option R&S RTO6-K31)
R&S
®
RT
O6
1188User Manual 1801.6687.02 ─ 05
7. Select the correct channels for the "Voltage Source" and the "Current Source".
8.
Select the "Settings" tab.
9.
Set the "SMPS switching frequency" according to your signal.
10. Select an "Optimize Scaling" option.
11. Tap "Execute".
On the screen, you can see the measurement waveforms of the current and the
voltage. Also, the result box with numeric measurement results is shown. For
details, see Chapter 19.6.1.1, "Output ripple results", on page 1184.
19.6.1.3 Output ripple settings
In the "Channels" tab, you set the current source and the voltage source, see also:
Chapter 19.2.1, "Channels tab", on page 1134 and POWer:RIPPle:CURRent
on page 2549)
In the "Settings" tab, you configure the ripple parameters and display settings.
Output
To Next Page
Loading...
