R&S RTO6 - 11.2.2.8 Slew rate

Search functions
R&S
®
RTO6
429User Manual 1801.6687.02 ─ 05
Slope, Range, Interv. width, ±Delta
Set the interval condition, see:
●
"Slope" on page 204
While the interval trigger can only analyze rising or falling edges, searching for a
width is possible for both edges at the same time ("Either").
●
"Range
" on page 204
●
"Interv. width" on page 205
●
"±Delta" on page 205
Remote command:
SEARch:TRIGger:INTerval:SLOPe on page 1610
SEARch:TRIGger:INTerval:RANGe on page 1610
SEARch:TRIGger:INTerval:WIDTh on page 1611
SEARch:TRIGger:INTerval:DELTa on page 1610
Level
Sets the voltage level for trigger search. The value is used for all search event types
that require one trigger level. The search trigger level is search-specific, you can define
different levels in different searches for the same event.
Remote command:
SEARch:TRIGger:LEVel[:VALue] on page 1607
11.2.2.8 Slew rate
The slew rate search settings are the same as the slew rate trigger settings. To apply
the trigger settings to search, tap Copy from trigger A'.
The slew rate search is not available if the search source is a digital channel.
Search setup