Remote control commands
R&S
®
RTO6
2468User Manual 1801.6687.02 ─ 05
TDRT:CALibration:SAVE:NAME <Path>
Sets the file name, file format and path of the TDR/TDT calibration file to be saved.
The file format is always .xml.
Parameters:
<Path> String with path and file name with extension .xml
Usage: Asynchronous command
TDRT:CALibration:SAVE[:EXECute]
Saves the TDR/TDT calibration results to the file that is specified with TDRT:
CALibration:SAVE:
NAME.
Usage: Event
Asynchronous command
24.20.2.2 Measurements
TDRT
:STATe................................................................................................................2468
TDRT:CALibration:USECaldata..................................................................................... 2468
TDRT:BW....................................................................................................................2469
TDRT:DOMain............................................................................................................. 2469
TDRT:PERMittivity........................................................................................................2469
TDRT:SIGNal<m>STATe...............................................................................................2469
TDRT:SIGNal<m>:SCALe............................................................................................. 2470
TDRT:SIGNal<m>:OFFSet............................................................................................2470
TDRT:SIGNal<m>:POSition...........................................................................................2470
TDRT:SIGNal<m>:DATA:HEADer?.................................................................................2471
TDRT:SIGNal<m>:DATA:VALues?................................................................................. 2471
TDRT:STATe <State>
Activates or deactivates the TDR/TDT measurements.
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
TDRT:CALibration:USECaldata <UseCalibrationDat>
Disables or enables the frequency response calibration. Without calibration, the mea-
sured signals are only rescaled, and you can see the impact of the frequency response
calibration on the time domain waveform.
The command is not relevant when measuring with default values.
Pulse Source and TDR/TDT Analysis (options R&S RT
O6-B7/K130)
To Next Page
Loading...
